need help to ID an orion monitor

pinnut

Active member
Joined
Aug 3, 2010
Messages
1,084
Reaction score
20
Location
New York
its in a midway touchscreen arcade game.

see pics

the crt image is a little out of focus. adjusting the focus on the flyback doesnt help. it has to be all the way down. increasing it only make the focus worse. i was going to cap kit it and see what happens, but dont know what kit to get.

thanks
 

Attachments

  • 20160921_105819.jpg
    20160921_105819.jpg
    199.2 KB · Views: 29
  • 20160922_121752.jpg
    20160922_121752.jpg
    191 KB · Views: 26
that serial number didn't come up in WG database so you will need the other sticker that should be on it to figure out the model number. a tube number only tells us its a 19inch monitor tube (A48). i have the best nichicon 105c cap kits for almost any WG chassis.
 
found a sticker says p757d , so i believe its a k7201. i'll attach pics. also, there is a little coil that is askew. can i just stack it back on top of its mount, maybe with a dab of epoxy on the side to hold it, or do i replace it ? dont even know what it is :)

thanks
 

Attachments

  • 20160923_114942.jpg
    20160923_114942.jpg
    212.3 KB · Views: 16
  • 20160923_114951.jpg
    20160923_114951.jpg
    215.5 KB · Views: 15
  • 20160923_115029.jpg
    20160923_115029.jpg
    206.4 KB · Views: 12
yes a little blob of epoxy, crazy glue, super glue will work just fine.

set something on the top of the coil until the glue dries.

Peace
Buffett
 
i would start with a good cleaning of the pcb, glue your part after clean so it has a better adhesion and then a cap kit. let me know if you need a top quality kit.
 
Back
Top Bottom