Need a Weels Gardner d9200 33" yoke

You can use the well's number on the yoke

to search for the yoke.

Its seems that the 27" and 33" use the same yoke

but have circuit difference part change listed in manual.

You would not need to make any changes to the board.

What is wrong with the yoke?
 
You can use the well's number on the yoke

to search for the yoke.

Its seems that the 27" and 33" use the same yoke

but have circuit difference part change listed in manual.

You would not need to make any changes to the board.

What is wrong with the yoke?

I dont have the original. I want to use the chassis which is in like new condition on a 33 inch showcase with a good tube. Dont know original monitor manufacture. It missing chassis. The monitor works with wells chassis, but the horizontal width is narrow, the adjustment does nothing. The pincusion has no correction. I could play with the caps and try to tune it to the yoke but It would be easier to just swap yoke and reconverge.

If the yoke is the same, I do have another yoke from a 27" but its the non-removable glued on type. I already did get it off the bad tube, but I was planning on using that on another 27" tube from a TV i got that tests like new.

So in the end still looking for a yoke.

Thx

Thad
 
Back
Top Bottom