Need a little help with WG6100

Area69

Active member
Joined
Apr 14, 2008
Messages
990
Reaction score
63
Location
Plant City, Florida
I have two wires from the neckboard, one gray and one black. They were not connected to anything when I got them, not sure where they should go.

Then I have the black wire from the mainboard, connector P101, it is just hanging off.

And last, a black wire, from pin 3 of the connector on the high voltage board, it goes nowhere. I can post some pictures if that would help.

If anyone could take a look at their monitor and let me know, I would be most greatfull.
 
Both wires should have eyelets on them and get mounted to the frame bottom.
Should be in the schematics for the 6100 listed as grounds.
Should be 3 Black on one bolt and 2 gray on the other as pictured
attachment.php
 

Attachments

  • 002.jpg
    002.jpg
    88.5 KB · Views: 41
So both the black and the gray from the neckboard go to chassis ground? Do the other two go to the chassis also?
 
the gray wire thats soldiered to the neckboard goes to the frame (has the eyelet), the black wire thats soldiered to the neckboard goes to the deflection board attaching by a single pin connector. all in all you should have 3 black eyelet ground connectors, and 2 gray eyelet connectors attaching to the frame as pictured. If they dont have eyelets on them then refer to the schematics and trace your pin locations.
 
Alright, I think I have it now. Several of the wires had corroded and the eyelet was missing. But I now have three black and two grey going to chassis.
 
Back
Top Bottom