Need a Killer Instinct board schematic

MrSinister

Well-known member

Donor 9 years: 2015-2022, 2024
Joined
Dec 30, 2008
Messages
1,785
Reaction score
114
Location
Pittsburgh, Pennsylvania
I need a killer instinct schematic for the board. I need to make a couple jumpers and can't find where to solder them too. I have the manual but nothing in it on the board.
 
Never thought to look there...thanks
My board has some bad surface solder that just wont make a good connection...
Anyway what's the best gauge wire for jumpers and where should I get them at?
 
Depends on how long you need it to be. If it's going to bridge other traces it might short to, just use some insulated wire like is used for the harness. If it's short, just use a clipped component lead...
 
Ok..i went radioshack today the smallest they have is 22 gauge..that's way too big..
Where else could I look for higher gauge wire. I don't have any other electronic specialty stores around
 
Btw I'm working on the ki u96 chip. It almost boots stopping just shy of a full blue screen. There's three pins on it that don't make a connection that I want to just jump.
 
I have never been able to find any schematics for KI. I dont think they were ever released. If you find them post here!
BTW, radio shack has the wire you need. Its called wire wrap. Its great for repairing traces and such where you need really small wire.
 
Talked to scott seems its never been found...sigh but I have an idea ...it will take lots of time but I hope I can make one of the kiu96 chip
 
there aren't any that have been found still to this day. I picked up a proto manual thinking it might, unfortunately that was not the case.

hit up chad @ arcadecup.
 
Back
Top Bottom