You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser.
Museum of the Game® & International Arcade Museum® Forums
EDIT nvm im an idiot and forgot about the k7000 having the 50-60hz pot and apparently both k7000s i had were set to where capcom boards like them but not nba jam
Any idea what could cause this fold over at the bottom and stretching at the top of this NBA Jam PCB?
This is a board problem NOT A MONITOR problem. Every other game board looks totally fine every k7000 I put in it has the same issue. If I test the k7000 with a different pcb it looks completely fine no problems. All roms pass. Voltage measured from the roms is spot on. I have reseated all socketed chips but have not done a full socketed chip cleaning with the deoxit treatment yet. Cleaned edge connector.
Ive checked a street fighter 2 boar and marvel vs capcom with the same exact monitor and set up and i have no issues with the vertical