Namco Gun not working HELP please!

rcaido

Member
Joined
May 21, 2009
Messages
343
Reaction score
3
Location
Olympia, Washington
So my Point Blank 2 was working fine a couple weeks ago, i then turned it on & now the gun is not working.

If i pull the trigger it fires but the recoil does not work & also will not move anywhere on the screen except the middle of the screen. Anybody know the problem?
 
gun game

go into the service mode and try recalibrating the gun.

There is a driver board for the feed back on the gun. possible fuse blown.

Your connector(s) from the gun to the wirring harnes are not seated properly. The connector from the gun to the board is a bit off.

RJ
 
time crisis gun problem

Hi guys,
I have a similar issue, but mine affects the light gun component. The trigger is working, but the shot indicator is permanently at the lower left of the screen no matter where the gun is positioned. I've tried a second, working gun that has been re-hosed but the fault remains. I'm suspecting the gun drive PCB. Has anyone else seen this issue as well?
 
go into the service mode and try recalibrating the gun.

There is a driver board for the feed back on the gun. possible fuse blown.

Your connector(s) from the gun to the wirring harnes are not seated properly. The connector from the gun to the board is a bit off.

RJ

I tried recalibrating it.

Driver board? How do you replace the fuse? Is it in the gun itself or the gun pcb?

I've checked all the connections from the gun harness & all seem right, so im guessing its the driver board or the gun pcb got fried?
 
Back
Top Bottom