My whites are yellowish and my blues not so blue

SavePointVG

Member
Joined
May 31, 2012
Messages
370
Reaction score
1
Location
North Carolina
Hey gang,
I just did a rejuvi on my PC10 since red was starting to take over the whole monitor. The process worked and fixed that issue. This rejuvi however was not completely functional- I have a BK 467 and a fellow KLOVer made an adapter for me. 1/3 of the meters would give me readings.

By following a guide very closely I was able to go through the process semi blind which was probably not wise. But that being done, red no longer takes over, I no longer have the jail bars and my duckhunt gun is working like a dream.

The only issue now is my whites are kind of yellow and my blues are not as deep as I would like. I fear this may have resulted from the shotty rejuv process since adjusting the color knobs on the neckboard dont seem to have much effect. The chassis needs a cap kit but other than that Im not really sure what the issue may be.

Anyhelp would be great!
 
cap that thing and give it new life.

set the B+ to 108vdc

adjust your 2 brightness pots and the fly.

then center all the pots on the neck board and adjust from there.

Peace
Buffett
 
Last edited:
I'll also add, reflow all the color drive transistors on the neckboard too. only cause a majority of the EZ's I've capped wound up having colors drop out due to bad solder joints.

have to consider these things are usually 30+ years old now.
 
Back
Top Bottom