I don't have it nearby right now, but I believe I only have two LED's on my board. One for power and one for "disk activity"... Need to verify that though.
What is the current issues that you have with your board?
If there's no picture, try the VGA port and see if it is set to that output.
I don't have it nearby right now, but I believe I only have two LED's on my board. One for power and one for "disk activity"... Need to verify that though.
What is the current issues that you have with your board?
If there's no picture, try the VGA port and see if it is set to that output.
sorry, figured it out! i had one stay on green and then one orange when its suppose to be blinking green til they load i believe. anyway i had a bad switcher it turned out only giving 3.2v. i checked it before i even started this conversion and had 5v but i guess it went south after awhile. new switcher installed at 5.2 and all good!