Can someone give me some tips on how to repair the edge connector on one of my Ms Pac boards? A few of the traces got hot and lifted from the board, so I'd like to repair them before plugging this board back in to prevent further damage. The cause of the burned board was a weak harness connector, which I have replaced, but I want the board fixed now too.
3 or 4 of the traces are curled up a bit - how do I glue them back down?
I know I saw a site/thread on this somewhere a while back, but I can't remember where I saw it....
3 or 4 of the traces are curled up a bit - how do I glue them back down?
I know I saw a site/thread on this somewhere a while back, but I can't remember where I saw it....
