Mousin Around Center Target Motor Error

timbre

New member
Joined
Sep 8, 2005
Messages
1,010
Reaction score
2
Location
Washington
So I am having some issues with the center target motor and diverter
on my Mousin Around.

When I start the game and go into test mode I get error messages on
the motor and diverter


Malfunction Motor UP
Malfunction Motor Down
Check Diverter


Or pretty close to that. I have checked all the switches and they
work. Where can I head with testing to find the error on the motor?
According to the schematics it is special solenoid 11 which goes back
to q16. I have checked Q16 and it seems to test ok.


thanks in advance.
 
What does it do in game mode??
This might be relevant...
I once had a TOM, and the game would often complain about trunk errors. The trunk would spin, and all of the otpos seemed to register, yet it would often give errors, and the game would disable it. It turned out, that the 12 volts going to the motor was low. I replaced the associated bridge rectifier, and it spun much faster. So basically the motor was slow in turning the trunk. The problem is- the game would want to see a switch closure within a specified time frame of turning the motor on. If it turned the motor on, and it didn't see a switch closure within xxx seconds, it would give errors.
-Mark
 
Back
Top Bottom