Monitor connector question

THE COUNT

New member
Joined
Jul 16, 2008
Messages
828
Reaction score
11
Location
brenham, Texas
I was wanting to know what the pin size (.062", .093"......) is for the typical JAMMA cab monitor is. I'm not reffereing to the connector on the actual monitor chassis. I'm reffering to the one that is a 2 row six pin connector that connects to the cabs wiring, with about 1ft. or so of wire between it and the one that connects to the chassis.

I need to wire up 2 of these since 2 of my cabs have sh*tty hacked up connections in place of these on the WG's in them. I might order a small assortment since shipping on 2 sets of these will probably cost 10X what the parts do, but I want to make sure I get the right size on these specifics.

This is what I think I'm looking for, but am still unsure as to it being a .062" or .093".....
http://www.mouser.com/ProductDetail/Molex/03-09-1064/?qs=Vtbn2VVmZzHGbNUhvUSs5w==
 
Here is a pic of the female connector I am reffering to. In one of my games someone just ran male pins into this connector = FAIL.
 

Attachments

  • DSCF0386.jpg
    DSCF0386.jpg
    87.4 KB · Views: 17
Back
Top Bottom