jasonlyvers
New member
Not sure how to replace a wire that has a molex connector on it. Would assume it is a known pin size, but I'm not sure how to find it.
I have a DK that I should have let die. The power cord has rubbed through the insulation and needs to be replaced. If I cut off the bad spot, I need to rewire it to the connector in this picture. It looks like the original molex, I just don't know how to get the pins (or whatever) to replace the cord.
Same basic issue with these wires. This picture is from the side of the power supply. The wire was cut and taped, would like to just replace that wire, but need to get it back inside the molex.
I have a DK that I should have let die. The power cord has rubbed through the insulation and needs to be replaced. If I cut off the bad spot, I need to rewire it to the connector in this picture. It looks like the original molex, I just don't know how to get the pins (or whatever) to replace the cord.
Same basic issue with these wires. This picture is from the side of the power supply. The wire was cut and taped, would like to just replace that wire, but need to get it back inside the molex.