MK4 - 1 inch, left side of monitor

AAirhart

Well-known member

Donor 2011-2012
Joined
Jul 1, 2011
Messages
1,932
Reaction score
17
Location
Crafton, Pennsylvania
Using the remove adjustment board, I can't get the picture to move over any further.
20120303_193255.jpg


And the right is looking a little squished. Any suggestions? Not entirely sure of the model of the monitor. Flyback is a little rough to adjust (small adjustment holes facing to the right through a metal bracket), if that helps.
 
remote board is pretty similar to the one for the polo in my mk2. ill go down in the morning and snap a few pics.
 
This one is a 25in Neotec NT-25.
Also found the manual in the cab. The manual says to adjust R402 and L403, found R402 on the remote board..but not quite enough room to get a good look to locate L403. From the diagram, it appears to be behind the flyback and back to the right.

Would this do it? anyone familiar with Neotec monitors?
 
I think that should have a horizontal position setting, which would be 3 pins that say like L C R (meaning of course, left, center, right). might be a yellow wire... and I think it's toward the back of the chassis (meaning towards the tube, not you lol)

verify that it's on C. also don't do it while it's on.

that's about all I have right now..
 
Back
Top Bottom