Midway "Sounds Good" board...

descrentl

New member
Joined
Nov 20, 2006
Messages
5,774
Reaction score
13
Location
Redford, Michigan
So, on my Rampage, the sounds dont work. Its just a really loud hum. Ive tested the amp in a TRON, so I know its good. So that leaves the sounds good board. Any clue where I sould begin to troubleshoot it? I get the blinking green LED when its powered on. Are those blinks troublecodes, or just a boot up LED? I reseated the removable chips, but it didnt help. When I first got it, I was messing with it, and I heard some sounds, with the loud hum for a few seconds, then it dissapeared, never to return. Not sure if its worth my time to fix, or just get another one. But Id like to try. Any help would be great. Resolder the pins for the connectors? Thanks
 
Sure, let me know how that works out for ya. And maybe you can help me out. I'm not sure if Rampage uses the same interface on diagnostics or not, but I'd like to compare notes on your service switch of the Rampage. I think the architecture is similar on both
I'm running a Xenophobe and apparently it never gets through the entire test it just reboots the machine at the end.
It states Warning in red, that pressing the service button again will CLEAR ALL BOOKKEEPING in red, and below that, unhighlited, DO ALL POWER UP TESTS.
When I press the service button again, it reboots the machine. And never reports any results of any power up tests. Is it supposed to do that? Is that what your Rampage does?
Seriously need to get this K7000 capped. The focus is fuxored.

Will check this out. Thanks!
 

Attachments

  • DSC02406.jpg
    DSC02406.jpg
    98.5 KB · Views: 20
Last edited:
Back
Top Bottom