Midway kickplate molding?

timiskander

Well-known member

Donor 3 years: 2011-2012, 2017
Joined
May 3, 2006
Messages
2,667
Reaction score
61
Location
Fayetteville, New York
Does anyone know if/where you can get this besides arcadeshop & mikes arcade? I need some for my rampage cab, but its 28" wide instead of 23"
These 2 have it pre-cut to 23" only.
cheers
/Tim
 
Sorry sending from my phone and got cut off. It's fine I was a little upset because it was not cut exactly at a 90 angle and was probably a centimeter or two short. I ended up not using it anyway because I put on new front art and its home use so wanted to display the whole front. But from what I could tell it looked like the original. Was a little stuff but I did not see any difference in shape or design.
 
That should have said "was a little stiff" but next to the original I did not see a difference in the shape size or design.
 
I can post pics if anyone is intersted in the look assuming I can still find it.
 
this is the one from twistedquarter. I buy from them quite often, great supplier. I bought it to put on my Tron. If the old one on my Tron is original, then this matches exactly. Hope that helps.

this is 30" long
 

Attachments

  • IMG_1913.jpg
    IMG_1913.jpg
    96.3 KB · Views: 30
If it's stiff, then it's probably the same type that I bought for my Ms Pac - a repro run, and the material used is much stiffer than the original, more supple rubbber/plastic.
 
Back
Top Bottom