Matsushita left edge curving

wsharp

Active member

Donor 2021, 2025
Joined
Jun 26, 2009
Messages
169
Reaction score
86
Location
Pennsylvania
I have a Millipede machine with the original Matsushita monitor in it. It has curving on the left edge of the screen. I installed a cap kit a few years back and it did nothing to help the problem. If I narrow the picture with a potentiometer on the monitor chassis, the problem still exists.

Before I just try another cap kit, does anyone know which specific caps are responsible for this problem? Or what else might be wrong. Thanks.

100_5379.JPG
 
Have you tried tweaking the horizontal hold adjustment?

DogP
 
I had a similar issue with the Mats. in our Dig Dug. A cap-kit helped the problem but didn't solve it.

I ended up putting a new Big Blue in it as a pre-caution and wouldn't you know the curl completely went away. ;) Not saying it'll definitely work for you but you may as well give it a shot(if you haven't already replaced Big Blue).

Good luck. :beerchug:
 
Thanks guys. It turned out to be the horizontal hold. I missed it back there in the middle of the circuit board. And I didn't even electrocute myself as I adjusted it. :)
 
Back
Top Bottom