Marks ESB kit install help

knight rider

Member
Joined
Sep 13, 2008
Messages
509
Reaction score
16
Location
Illinois
Need some help and info.....

Have Marks ESB kit, and installed it per his instructions on the website. Heres my problem:

The sound board on the top is on an angle, and its sitting right on top of the chips on the daughter board. The daughter board is pushed in all the way as far as the pins will allow it, but there is a gap on all the pins from Marks board to the star wars boards. What I mean by that is I can see them out of there sockets, but there all the way in, its like all the pins are too long........ All the boards in his kit, are doing the same thing, sitting up to high....or..... Is this normal???
Are the pins to long and it should be sitting on the sockets?

Any info would be great
Thanks
 

Attachments

  • Picture.jpg
    Picture.jpg
    88.7 KB · Views: 21
  • Picture 126.jpg
    Picture 126.jpg
    91.8 KB · Views: 17
  • Picture 127.jpg
    Picture 127.jpg
    82.4 KB · Views: 21
Last edited:
That looks normal to me... mine is the same way. There's a slight flex on the sound board, but there's no electrical contact, so it's fine. You could probably cut the pins down a little bit if you've got a problem with it, but you'd have to be careful not to screw up the sockets, or cut the pins too short.

DogP
 
Back
Top Bottom