Makvison 24.8" M3125 yoke readings...

tg2051

New member
Joined
Feb 26, 2008
Messages
34
Reaction score
0
Location
St. Pete, Florida
Anyone know the proper readings for the yoke used on the tri-sync Makvision M3125?

Here is what I am reading...

Vertical/green->blue = 4.8 ohms

Horizontal/red->blue = 0.8 ohms

I am replacing the Wei-ya chassis with an exact replacement, but want to verify that I do not have a yoke issue before firing this up and potentially blowing the new chassis.

Any help is much appreciated!!
 
You should be measuring Green - yellow
That's all the info any company needs to determine a high or low impedance chassis is needed.
 
Last edited:
Dips__t answer.... if your going to answer, read the question...

I love how you get people who know little, that think you know less, answer a post telling you something you already know... which has nothing to do with the question...

I SAID I WAS REPLACING THE CHASSIS (BRAND NEW REPLACEMENT) WITH AN EXACT, REPEAT EXACT, REPEAT EXACT, same chassis as the one that come on it originally.... so why do I care about trying to match the impedence of the chassis to the tube???????????????? I DON'T!!!!!!!!!!!!!!!!!

I just want to verify if the yoke has a short or is wacked out (actually I know it has no short as I do not have any 0.0 ohm readings... but it could be wacked out... can someone please read the question and answer the question accordingly, assuming you have knowledge of the proper values.
 
Back
Top Bottom