Talon2000
Well-known member
I've got a Makvision model 1514 CH-203 13" monitor. Looking for a manual.
The Horizontal width is a bit big, can't seem to get the image small enough to fit. Adjusting the Hcoil does shrink it to a point, then it start increasing just a bit.
There is a Jumper for Narrow and Wide, if placed on Narrow the picture is close to fitting, on Wide it's definitely to large. Wondering if I can get more adjustment out with a component change..
Other than that the picture is crisp and clear.
The Horizontal width is a bit big, can't seem to get the image small enough to fit. Adjusting the Hcoil does shrink it to a point, then it start increasing just a bit.
There is a Jumper for Narrow and Wide, if placed on Narrow the picture is close to fitting, on Wide it's definitely to large. Wondering if I can get more adjustment out with a component change..
Other than that the picture is crisp and clear.