Make a Cocktail of not?

SideArms

New member
Joined
Sep 24, 2009
Messages
44
Reaction score
0
Location
Platteville, Wisconsin
Well Guys, I know it's probably been asked a lot and it's old but I have a valid question.

I have a Centipede pcb, harness, arII, and the likes and was wondering if I could make a cocktail cab for it? I've seen a few and they look like a fairly simple design. I can weld the legs like the tables seem to have and I have your typical woodworking tools.

Just wondering if anyone has any better ideas considering I cannot seem to find a cocktail in this area to convert? Also, would anyone have one that I could get some pictures of if I decide to make this table from scratch?

Thanks In Advance
 
Looks like a pacman cocktail

Drewster,
looked up arcadeshop and their cabinets look like pacman, all centipedes I've seen are completely different than that.

Maybe I'm wrong?
 
Well if you wanted a genuine Atari-like cabinet, youre better off waiting to find one. That is, unless someone here can give you measurements and pictures and youre up for the challenge.
 
Actually you are right, I don't think it would be that bad to re-create the Atari cocktail. I have a few of them and I might make one from scratch. It's really just tubular steel and some channel. The wood part isn't terribly complicated, if people are making the Joust cocktails this should be a walk in the park. Are you going to make your own CP's too? Again pretty basic assuming you have a brake.
 
Back
Top Bottom