Finally got an excuse to try out the new-to-me desktop mill I picked up last month from Craigslist. 
I had one last Neo Geo to fix for a member here that I've been VERY late in getting fixed, but it was missing a standoff and the ones I have here are too long.
I measured and marked it then put it in the mill vise and trimmed it right down to size. After that it went in the Unimat micro lathe and had the sharp edge beveled down.
It fit perfectly in the MV4FS2.
I had one last Neo Geo to fix for a member here that I've been VERY late in getting fixed, but it was missing a standoff and the ones I have here are too long.
I measured and marked it then put it in the mill vise and trimmed it right down to size. After that it went in the Unimat micro lathe and had the sharp edge beveled down.
It fit perfectly in the MV4FS2.
