Kmp2935-v korion

paul400

Well-known member
Joined
Nov 8, 2010
Messages
2,416
Reaction score
219
Location
Hixson, Tennessee
anyone every work on one of these beasts? its out of a 27 inch VGA monitor. I cant find any information on it not even a schmatic. symtom is a clicking and wont power on, when powered off the clicking slows thens stops. any info would be helpful, thanks
 

Attachments

  • 008.jpg
    008.jpg
    100 KB · Views: 9
  • 004.jpg
    004.jpg
    85.9 KB · Views: 8
  • 002.jpg
    002.jpg
    94 KB · Views: 11
Last edited:
Pull the HOT and test it.

tested the HOT in circuit it seems to be completley shorted. I will test later out of circuit if I can find a flyback also which seems impossible. checked one of the sites and wasnt allowed to access it, must be north koria.
 
I don't know, but if parts are not available I am not going to put a HOT in just to find the flyback is bad. Until I get more information and parts avalibilty I am not not wasting time or money.
 
ok pulled the HOT and completely shorted at all points so I purchased a new one from china, didnt cost to much and I will give it a shot.
 
wanted to give a final report on this monitor. HOT took 3 weeks to get. installed it and hooked everything up, picture came up to horizontal collaspe. within a minute I started hearing high voltage leaking and then the HOT blew. Oh well I tried, not waiting again for a HOT, I will take off what I can use and scrap the rest.
 
Back
Top Bottom