KI lifted trace at the risc processor

eviloval

New member
Joined
Dec 13, 2008
Messages
22
Reaction score
0
Location
San Leandro, California
My KI board was originally tossing me "SRAM error can't setup credit interup While taking a good look at the board I noticed there was some glue on a few legs in the corner of the Risc chip (the one with a heat sink on it). After removing the glue it turns out that 2 of the legs don't have a trace under them. After digging around at the other 2 KI boards I have laying around it appears that this trace goes no where. Could this trace be only something to hold down the pins? Or is it a gound of some sort (there are no other traces that attach to it and I've dug into one of my total loss boards and found nothing. If anyone has a pinout that would be a life saver. Any help would be appreciated.
 
Back
Top Bottom