K7400 - c155 and r100 location?

pun84

New member
Joined
Oct 9, 2009
Messages
129
Reaction score
1
Location
New Jersey
Can anyone tell me where on the PCB these components are, either I am blind or they are not present...
 
R100 is not present for the 7400 and has a jumper at that location (just behind and to the left of the width coil).

Where did you come up with C155? There are no caps in the 100's section higher than about 127...on any of the versions of this chassis...
 
Randy fromm's flow chart for k7401-k7501.. I am getting B+ of 1-3VDC all of a sudden :eek:

Chassis was working fine yesterday and today its doing this :/

I found and corrected a couple of loose cold solder joints.. I might just cap it too a bit later.. but it was working with a nice picture!!
 
Back
Top Bottom