K7000 neckboard connector - size?

neopolss

Well-known member

Donor 6 years: 2013, 2016-2020
Joined
Jul 16, 2003
Messages
3,222
Reaction score
110
Location
Topeka, Kansas
I just replaced the flyback on my chassis and need to connect it to the neckboard. One of the wires from the neck I cut, and I can splice, but the other was a single pin connector, and silly me, I threw it out with the old flyback. Does anyone know what size and where I can get a new connector to crimp?
 
I just replaced the flyback on my chassis and need to connect it to the neckboard. One of the wires from the neck I cut, and I can splice, but the other was a single pin connector, and silly me, I threw it out with the old flyback. Does anyone know what size and where I can get a new connector to crimp?

Ugg, you cut the focus wire? There's some serious voltage running through that wire. It can burn through common electrical tape or heat shrink tubing. The neck socket flips open so you can unsolder that wire...and solder the new one back. Your other wire is the screen voltage. Unsolder the pin from the neckboard and solder the wire directly to the board.

Edward
 
I think he's talking about the wire that goes to the pin next to the socket - G1 or G2 or whatever....
 
I think he's talking about the wire that goes to the pin next to the socket - G1 or G2 or whatever....

Yeah, that's the connector he's looking for....but read the second sentence....cut and spliced the other wire. Focus is pretty much the only other wire left (when replacing a flyback.....well, except for the anode. I hope he didn't cut that....though, I've seen it done:)).

Edward
 
Yeah, that's the connector he's looking for....but read the second sentence....cut and spliced the other wire. Focus is pretty much the only other wire left (when replacing a flyback.....well, except for the anode. I hope he didn't cut that....though, I've seen it done:)).

Edward

When he said cut and spliced, I think he was referring to the dag wire. The focus wire doesn't have a connector...
 
The focus wire doesn't have a connector...

That's why I think he cut it:)

But you could be right....I wasn't thinking about the dag/ground wire. The OP mentioned flyback replacement....one wire had a connector....the other, he cut and spliced.....I immediately thought, focus.

Edward
 
Well, if he did he can heat shrink it he has to. I have and not had an issue....
 
Back
Top Bottom