Museum of the Game® & International Arcade Museum® Forums

1000002117.jpg
I have this K7000 that aaaaaaaalmost works after needing quite a bit of work.

I replaced IC2 and IC3, all new caps, checked ratings for all resistors in the vertical and horizontal circuit, adjusted 50/60hz pot, H-hold, V-Size, etc. and this is as close as I can get it.

Hard to tell from this image, but the top 3" or so has folded over, is upside-down, and creates an interference pattern anywhere it intersects with any other image being displayed.

I have sync on pin 10.

Any suggestions?
Back
Top Bottom