K4900 vertical pos

Soonerfan1066

New member
Joined
Jun 24, 2011
Messages
179
Reaction score
0
Location
Yukon, Oklahoma
Hi i am in need of some help i have a wg 4900 and a recent cap job and flyback.Its vertical is to low it has a pot to adjust it not the positioning wire.The pot works just does not adjust it enough so the picture is to low on vertical.Any help would be appreciated.
 
Is the pot mounted near the flyback on a little board sticking up from the main chassis? It's possible that you are at the limits of what it can do. What board are you using it with?
 
Make sure you have adjusted horizontal and vertical sync properly as described in the manual (involves shorting a weird pin during adjustment). This monitor, more than any I've ever adjusted, will move the picture up/down and left/right quite a bit depending on the position of the sync pot.

Otherwise there's the position jumper described above.
 
Is the pot mounted near the flyback on a little board sticking up from the main chassis? It's possible that you are at the limits of what it can do. What board are you using it with?
yes the board is near the flyback and it has reached its limit just not enough.Thanks for the reply.
 
Back
Top Bottom