Museum of the Game® & International Arcade Museum® Forums

Here's a good question for the monitor gurus.

I recapped and reflowed a K4600 for a buddy to use in his Kickman. It worked great except for the image being too low on the screen. We tried adjusting everything, but couldn't move the image high enough.
I pulled my stash of rebuilt K4600 daughter boards out and we kept swapping them until we found one that put the image high enough.

What causes this? There isn't a whole lot of components on that daughter board? Are there some of the resistors that go out of spec and need to be replaced?
Back
Top Bottom