johnnyselman
Member
First let me say, I'm no monitor guru but have done a few cap kits that worked out. I'm working on a WG K4600. The pictures below is what it looked like Before and After the cap . No Change! I don't know how to describe it. It is way to narrow and part of it is doubled.I and reflowing pins and connector housing. Buzzed out board connection point thru the connectors. B+ is 129. HOT checked good replaced anyway. I did the full cap kit . With filter cap and C621 axle cap. Neither the horizontal width coil or horizontal center pot(checked) has any effect. The Hor. width coil physically looks good, not broke ,center intact. I do notice that it never get warm if that means anything. Any Ideas?
Attachments
Last edited:
