Bullwinkle
Member
K1900 Monitor Brackets - I'm just not getting it...
Ok...I'm trying to install a b&w monitor into my Super Breakout project.(my first b&w)
Here's the monitor...

Here's the cab where the monitor will be installed...

And here's what's confusing me.

I have 2 of each of these rods but haven't quite figured out the puzzle of using them to connect the monitor to the bolts in the cab. It looks like I could run the shorter straight rod behind the monitor's frame and it would hold, but the "7" shaped brackets wouldn't get used in that scenario and I assume I should be using all 4 rods as they were given to me as a set.
I'd like to claim that I'm too tired, but I looked at this earlier and still didn't get it!
Any help/suggestions would be greatly appreciated. I'm sure I could rig it up, but I'd rather mount the monitor correctly.
Thanks,
-tom
Ok...I'm trying to install a b&w monitor into my Super Breakout project.(my first b&w)
Here's the monitor...

Here's the cab where the monitor will be installed...

And here's what's confusing me.

I have 2 of each of these rods but haven't quite figured out the puzzle of using them to connect the monitor to the bolts in the cab. It looks like I could run the shorter straight rod behind the monitor's frame and it would hold, but the "7" shaped brackets wouldn't get used in that scenario and I assume I should be using all 4 rods as they were given to me as a set.
I'd like to claim that I'm too tired, but I looked at this earlier and still didn't get it!
Any help/suggestions would be greatly appreciated. I'm sure I could rig it up, but I'd rather mount the monitor correctly.
Thanks,
-tom