junking out a eclipse that had a bad main board and pcb
monitor powers up and says no signal since the board is bad it is not getting a signal
15 inch lcd
remote control board and d sub computer monitor connector
it takes 12 volts to power up so it will need a wire hooked up to it for 12 and ground i will mark it
looking to get 40.00 shipped
the screen looks new
monitor powers up and says no signal since the board is bad it is not getting a signal
15 inch lcd
remote control board and d sub computer monitor connector
it takes 12 volts to power up so it will need a wire hooked up to it for 12 and ground i will mark it
looking to get 40.00 shipped
the screen looks new
Attachments
Last edited:

