JROK Taito (ZooQ) to 4600 Sync issue

cbigames

Well-known member

Donor 2014
Joined
Jan 30, 2014
Messages
1,077
Reaction score
382
Hooked up my JROK Multi Taito to 4600 in my Qix cabinet using JAMMA harness. Set to boot right to Qix. Comes up and plays fine. When I try to go to menu screen there seems to be a sync issue (screen all out of whack). If I start a game it starts and plays fine again. I can even get Qix 2 to play ok. Every time I try to get to menu same Sync problem . Any ideas how to fix ? C sync from JAMMA harness hooked to -h and -v on monitor.
 
Hooked up my JROK Multi Taito to 4600 in my Qix cabinet using JAMMA harness. Set to boot right to Qix. Comes up and plays fine. When I try to go to menu screen there seems to be a sync issue (screen all out of whack). If I start a game it starts and plays fine again. I can even get Qix 2 to play ok. Every time I try to get to menu same Sync problem . Any ideas how to fix ? C sync from JAMMA harness hooked to -h and -v on monitor.

Sounds like you need to adjust the h-hold or the v-hold on the 4600 to get a setting at which both the menu and Qix will sync. Here's a diagram of the hold pots for a 4600.

http://forums.arcade-museum.com/showpost.php?p=3226339&postcount=8
 
I had the same issue and enabled in the setup qix use 60hz(cant remember exact name) which seemed to have resolved the issue.

attached a pic of how I setup the sync wires.
 

Attachments

  • sync.jpg
    sync.jpg
    114.5 KB · Views: 46
Last edited:
Back
Top Bottom