So I am trying to get my Jr. Pacman going.. The power supply board has
3 Voltage regulator pots on it. I want to make sure it is outputing
the correct voltages. The manual is kinda lacking. Any idea what each pot
should be outputing? Where can I test the voltages? I dont see any
test points.
I'm planning on doing a full cap kit on it but... without more info...
Thanks,
Malice95
3 Voltage regulator pots on it. I want to make sure it is outputing
the correct voltages. The manual is kinda lacking. Any idea what each pot
should be outputing? Where can I test the voltages? I dont see any
test points.
I'm planning on doing a full cap kit on it but... without more info...
Thanks,
Malice95
