* * * JAMMA Stickers Galore! For your edge connectors * * *

Uh # 1 Jamma standard labels are wrong.

"M" is not test. It should be Right Speaker minus.

"S" is not coin 4. It should be Tilt/reset.

"dd" is not select down. It should be P2 ButE or optional.

"11" is not blank. It should be Right Speaker plus.

"15" is not coin 3. It should be TEST.

"26" is not select up. It should be P1 ButE or optional.
 
Uh # 1 Jamma standard labels are wrong.

"M" is not test. It should be Right Speaker minus.

"S" is not coin 4. It should be Tilt/reset.

"dd" is not select down. It should be P2 ButE or optional.

"11" is not blank. It should be Right Speaker plus.

"15" is not coin 3. It should be TEST.

"26" is not select up. It should be P1 ButE or optional.

Got some pinouts? - may just be another version
 
I already have my own JAMMA labels printing setup on my old laptop. I think it prints 20 or so of each (solder & parts) all on one page and of the correct size for the connectors. I did mine in Paperport software.
 
Correct. if you already have a template, just make the corrections to US standard and post. I'll use them....
 
Back
Top Bottom