Jamma Qix Monitor Help

Douchka

Member
Joined
Jul 18, 2010
Messages
482
Reaction score
4
Location
OC, California
So I have a relatively gutted Qix. Had a jamma (ugly) hack job which didnt work so I fixed it. Everything worked fine. Got the Qix board with adapter to work. Purchased a 60n1 & decided Id clean up the wiring rewire etc etc. with a new harness.

After getting to the Video sync RGBG Im getting this....Any ideas??

As for the chassis, Im no expert. Replacement Weiya?? no clue on model #

Thanks for the advice.
 
Last edited:
Labeling images

Definitely NOT a G07-907, doesn't like like a Wei-ya either but I may be wrong.

Your sync is off, and I can't tell if it just needs to be adjusted or if you need to change the polarity via one of those 2 black slide switches on the left hand side of the chassis.
 
Definitely NOT a G07-907, doesn't like like a Wei-ya either but I may be wrong.

Your sync is off, and I can't tell if it just needs to be adjusted or if you need to change the polarity via one of those 2 black slide switches on the left hand side of the chassis.

Those 2 black slides appear to do nothing. I found this schematic for an 820h yet it is slightly different then what I have

Reading other posts seeing that the b+ range could be the sycning problem causing shutdown since now I get nothing.

Really dont want to start adjusting till I get an idea that 1) 115 is correct 2) if not wont cause further if any damage to my issue if I adjust the b+
 
Last edited:
Looks like the Eygo G07 replacement chassis. This is a rebranded Wei-Ya. I have one also.
 
Adjusted the B+ and now were in business. Cant really pin point where I went wrong from working monitor - rewiring - non-working monitor.
 
Back
Top Bottom