Is your 720 Control Panel bent in the middle?

2600

Well-known member
Joined
Sep 22, 2005
Messages
5,197
Reaction score
231
Location
Ashburn, Virginia
I have an extra 720 CP that I'm selling that I've been listing as bent in the middle. I took a look at the CP that is currently on my 720 the other day and noticed it too had a bit of a bend. I was wondering if this was factory or perhaps caused by the CP latch position.

Anyone else have a bit of a bend around where the CP latches are?
 
Think mine might have a slight bend. Seriously doubt it's factory. Most likely poor design that allowed the latches to cause this bend over time.
 
None of mine are bent there. Probably could get there from leverage on that big joystick, especially if the front bolt is missing or broken through the wood.

Wade
 
Back
Top Bottom