Is there a jamma adaptor from jamma to Berzerk

[Dave27]

My Berzerk has no wire harness and I was wondering if i could throw in a jamma harness and then buy or make an adaptor to plug into the Jamma harness to go from jamma to Berzerk.Also would a switcher work or does Berzerk have oddball voltages.I havnt researched any of this but was planning on doing so today....Later....Dave

 

[HudsonArcade]

Switcher works fine... I even have adapters to put ATX supplies in stern games.

 

[parabolic]

I guess you could make up a Jamma adapter. It would be alot of wiring though.
If you need to run jamma - it may be cheaper and less "brain damage" to just buy a arcadeshop jamma board that already has Berzerk and Frenzy on it.
If you have the working boards and need to wire them up in an actual cab - Id say find or make an original harness up and run a switcher.

 

[Dave27]

Whats an ATX supply just a brand name of switcher.So there is no one who allready makes an adaptor. Great Idea on the arcade shop board but from what I hear they are expensive and dont recieve upgrades very often.Hmmm what to do.

 

[Oryk Zinyo]

Whats an ATX supply just a brand name of switcher.So there is no one who allready makes an adaptor. Great Idea on the arcade shop board but from what I hear they are expensive and dont recieve upgrades very often.Hmmm what to do.

ATX power supplies are a standard computer power supply for modern computers.

 

[parabolic]

ATX power supply is commonly used in PCs. Although there are Arcade video games that use them now as well. They carry the same (and more) voltages thn a switcher.
As far as the board goes - I guess its what you have and what you want. I had a berzerk (empty) cab to start with. I found all the parts for it, as well as the boards. I had partial harnesses to start with, then using the schematics, I managed to rewire the missing sections - and for the most part - it looks all factory. If you dont mind spending the time - then try that route. I dont know what you have already, but youd be farther ahead if you had the interboard wiring that connects all the boards together (no not just the ribbons). Youll still need to make your wiring from the boards to the controls though.
Its all about what you have more of - time or money.

 

[Dave27]

Hi thanks guys.I have 5 sets of boards that hopefully I can get a working set or two from.Only a few interconnects no power supply or wiring harness, and I still need a nice looking complete control panel

 

[HudsonArcade]

Whats an ATX supply just a brand name of switcher.So there is no one who allready makes an adaptor. Great Idea on the arcade shop board but from what I hear they are expensive and dont recieve upgrades very often.Hmmm what to do.

I can make you an adapter, but it won't be cheap....

 

[Phetishboy]

Switcher works fine... I even have adapters to put ATX supplies in stern games.

I think I would like one of these. I am also interested in your Taito to Jamma adapters. I PM'ed you about it, but got no response.

 

[Dave27]

So what would a Jamma to Berzerk adaptor run me approx.