NEW Interest: Gauntlet, Super Sprint, Rampart Single Correct Lip T-molding

markrl

Well-known member
Joined
Jan 20, 2014
Messages
2,404
Reaction score
598
Location
crystal lake, Illinois
Interest: Gauntlet, Super Sprint, Rampart Single Correct Lip T-molding

This molding which I have been looking for obviously does not exist. It's already in production and will have it soon. The double lip molding that most people and I have used just looks like shit and I have quite a few games I needed it for.

So the more Interest the lower I can offer it for. The cost for me is fixed and already paid for. So if you are interested in accurate reproduction molding, speak up.

I know for a fact that it was from the factory on the following games. I have duplicates of these games and all had this molding. If you can without a doubt add a game to this list please post. Most games that had a 3/4 wood cp with flat metal used this specific molding. It actually acts as a clamp for the metal to wood.

GAUNTLET
GAUNTLET 2
SUPER SPRINT
THE REAL GHOSTBUSTERS
BLADES OF STEEL
RAMPART
PIT FIGHTER
 

Attachments

  • 20170327_105332.jpg
    20170327_105332.jpg
    483.9 KB · Views: 134
I'm in for enough for a Gauntlet CP. Thanks!

Just measured my CP and it roughly 87" around.
 
Last edited:
I'm in for my Blades of Steel control panel and enough for a spare! So prob 10-12 feet.
 
I've never had any of those games... that T-Molding looks ... odd. How does it look installed?
I believe it was only used around the control panels, not the entire game. The CP is wood with a metal top, so the lip of the T-Molding basically grabs the edge of the metal top, but goes into the slot on the wood, sorta holding it all together as one piece. Without the lip on the T-Molding, the edge of the metal top would be exposed.

DogP
 
I will take some - just have to figure out how much I need .
 
I'll need this for a Gauntlet, Gauntlet 2, a few Super Sprints, and a few "Grampart"s as a friend of mine calls them ;-)
 
Back
Top Bottom