Interest Check: Fully Assembled Reproduction PCH1-02-ROM
Since I've starting to get low on my Bare Reproduction PCB's of PCH1-02-ROM (Batch 2),
I wanted to see if there was any interest in a Fully Assembled Reproduction of the PCH1-02-ROM.
It wouldn't be a parts kit. However, due to the nature of the PC-10 PCB.
Their would still be some soldering that would be need to be done.
Ie: the Soldering pads as require by different games.
It has yet to be decided if either the Socket for the Security Chip will be left blank or not.
As it can be seen in this picture, its been altered to allow for customization.
Currently there is no target date to start or complete this. But if their is in interest, I would like to do this by Early to Late Summer.
What are peoples feelings about putting this up as a Kickstart Project?
I would like to hear what peoples thoughts are on the Subject. Thanks
Since I've starting to get low on my Bare Reproduction PCB's of PCH1-02-ROM (Batch 2),
I wanted to see if there was any interest in a Fully Assembled Reproduction of the PCH1-02-ROM.
It wouldn't be a parts kit. However, due to the nature of the PC-10 PCB.
Their would still be some soldering that would be need to be done.
Ie: the Soldering pads as require by different games.
It has yet to be decided if either the Socket for the Security Chip will be left blank or not.
As it can be seen in this picture, its been altered to allow for customization.
Currently there is no target date to start or complete this. But if their is in interest, I would like to do this by Early to Late Summer.
What are peoples feelings about putting this up as a Kickstart Project?
I would like to hear what peoples thoughts are on the Subject. Thanks
Last edited:

