Interest check: Berzerk cp plexi

cnlmoore

Well-known member

Donor 2023
Joined
Jan 4, 2007
Messages
5,511
Reaction score
723
As the final run of Berzerk control panels nears completion, I thought I'd revisit the plexi cover idea. Depending on the interest level (min of 50), it looks like I can have these made in the $12 to $15 range. The plexi would fit just outside the four bolt locations in an effort to protect the artwork. Cut for buttons etc. I can ship them with existing panel orders, or if you already have a panel, shipping would be via USPS flat rate at cost.

This is not final, just an interest check. If I get enough interest I'll do a pre-order and get it moving.

Chris

Current interest level - 32
using them on frenzy brings it to - 35
 
Last edited:
I just got a fully restored berzerk with one of your panels, and sadly some of the paint is chipped off in one spot. I'd be interested in one of these if you get the numbers to run them.
 
I'd take one for sure. If you end up running short on the number you need, I could possibly take two to help out.
 
Will this also fit the Frenzy panels you made (I suspect yes)? If so, I would like (1) for Berzerk and (1) for Frenzy

Chris
 
I'm in for 2.

Bill
 
My panel from the first run still looks great. Are these really needed? Or will they cause more harm than good? I can see the screening getting adhered to the bottom of the plexi over time or at the very least getting rubbed off by the friction of having the plexi over the screening. I don't know, maybe I'm wrong.
 
Back
Top Bottom