ManiN
Member
Anybody got any recommendations for a clean install of a CPO on sheet metal.
I'm asking as I see so many that are split right at the curve on the front of the panel. this makes me think there is stress at that corner when installed cold and left that way. Can heat be applied in a reasonable amount by a heat gun or equivelent to releave this stress and therefore eliminate future breakage on that rolled edge? Or is this not the cause of this breakage in the first place?
Thanks,
Jake
I'm asking as I see so many that are split right at the curve on the front of the panel. this makes me think there is stress at that corner when installed cold and left that way. Can heat be applied in a reasonable amount by a heat gun or equivelent to releave this stress and therefore eliminate future breakage on that rolled edge? Or is this not the cause of this breakage in the first place?
Thanks,
Jake