Frax
New member
God, why do people DO this? I swear to god, I pulled this driver board to test these things, find out why my sling isn't working right? It's a Gottlieb system 3. There are 4 MOSFETS that were replaced.
3 different types of replacement were put in. They SHOULD be 2N10L's.
I've got the following in here...what the hell is this shit...
K1446 6M4
NEC K736 4X (2 of these)
NTE 934M NTE2885
Also looks like all of the header molex were rebuilt at some point, okay..fine...that hasn't been an issue...but the entire back of the PCB, every trace connected to those headers? The mask is bubbled, wrinkled, and flaked off in some places. Flux crud everywhere, really bad where the MOSFETS were replaced..one place literally covered in flux half the size of a dime..
My local electronics store did NOT have .156 headers, housings, trifurcon pins, OR any of the MOSFETS I can use or acceptable replacements, or they had them and I can't locate them due to the hodgepodge way their shit is laid out. I guess I could've asked, but if your store is THAT frustrating to locate parts, I don't feel like you deserve the business. I should've just ordered the shit online a week ago and would've had it in hand already, but NOOOOO...I try to do the cool thing and support a local mom and pop, and all I end up with is $6 wasted gas, no parts, and I'm f***ing pissed off...
3 different types of replacement were put in. They SHOULD be 2N10L's.
I've got the following in here...what the hell is this shit...
K1446 6M4
NEC K736 4X (2 of these)
NTE 934M NTE2885
Also looks like all of the header molex were rebuilt at some point, okay..fine...that hasn't been an issue...but the entire back of the PCB, every trace connected to those headers? The mask is bubbled, wrinkled, and flaked off in some places. Flux crud everywhere, really bad where the MOSFETS were replaced..one place literally covered in flux half the size of a dime..
My local electronics store did NOT have .156 headers, housings, trifurcon pins, OR any of the MOSFETS I can use or acceptable replacements, or they had them and I can't locate them due to the hodgepodge way their shit is laid out. I guess I could've asked, but if your store is THAT frustrating to locate parts, I don't feel like you deserve the business. I should've just ordered the shit online a week ago and would've had it in hand already, but NOOOOO...I try to do the cool thing and support a local mom and pop, and all I end up with is $6 wasted gas, no parts, and I'm f***ing pissed off...
