Ice Cold Beer - Questions and concern

Silverunicorn

Well-known member

Donor 2011-2012
Joined
Aug 18, 2010
Messages
4,810
Reaction score
416
Location
Quakertown, Pennsylvania
Hi all!

Recently got an Ice Cold Beer machine. I'm no good at it but am enjoying it.

I think the metal ends on my bar are backwards compared to others I have seen. I have attached photos. 1) Is this the case, and 2) does it matter?

Additionally, I have had the machine reset randomly during gameplay. It just stops, resets to game over, and clears all credits. Then it typically works fine again.

Any ideas what that may be? I am guessing maybe a power supply issue?

Thanks in advance! I already got a replacement glass from PhoenixAecade (which is awesome).


Chris
 

Attachments

  • IMG_1142.jpg
    IMG_1142.jpg
    92.8 KB · Views: 20
  • IMG_1143.jpg
    IMG_1143.jpg
    78.4 KB · Views: 18
  • IMG_1144.jpg
    IMG_1144.jpg
    70 KB · Views: 18
I'm not sure it matters which side that little wire is on. I think I see that the plastic connector right next to it is broken though. That's a bigger deal. You can 3D print replacements.

Regarding the resets, did you do the typical first steps? Confirm 5v at the board. Then clean the edge connectors. Reseat any socketed chips.
 
I will do those first steps, I have not yet. I don't have a 3D printer so I'll have to find someone that might be able to make those for me.

Thank you
Chris
 
Back
Top Bottom