iCade PCB - Trackball not working...

Killert6969

Active member
Joined
Apr 16, 2008
Messages
1,113
Reaction score
18
Location
Coram, New York
I finally got around to setting up my multicade icade 60-in-1 and everything works great except the trackball. I bought the arcade shop JAMMA harness (wired for trackball) and everything seems to be connected correctly. However, the trackball does not work. Is there a particular way to set the trackball up on the setup screen? I only see two options pertaining to a trackball and neither switch worked. I did notice that on the setup screen it states * Trackball = Cursor. I haven't figured out this clue yet.

Any help would be appreciated!
 
so do you have it plugged in to con3 on the pcb? is it plugged in the proper way? though backwards should still give you something.
is it a happ trackball with the red pcb's?
 
It is not plugged into Con3. The trackball is plugged directly into the JAMMA harness that I bought from Arcade shop. Should I simply run it to CON 3? Do you know what style molex connector that is off hand?


so do you have it plugged in to con3 on the pcb? is it plugged in the proper way? though backwards should still give you something.
is it a happ trackball with the red pcb's?
 
Depending on which 60 you got, it may not work on the CON3 connector, but should work when connected to the Player 2 side of the JAMMA harness. Perhaps there is something wrong with the wiring? Or perhaps you have the wrong type of trackball?
 
whatever you do, do NOT connect or disconnect the trackball when the game is powered on. Also, do not drill the control panel/trackball case (such as boring the hole a little bigger) either when the game has power - you will fry an optic board.
 
Back
Top Bottom