icade on a 19" K7000

gobsgraham

Member
Joined
Mar 26, 2009
Messages
649
Reaction score
17
Location
AB, Canada
I can't get this to hold quite properly. No matter what I do it is like this. The K7000 19" monitor came out of a MACH3 cabinet that was converted to Mortal Kombat (Yawdim bootleg). It was fine in there as seen in the second picture. I have tried a few different jamma newer jamma boards and they all do the same thing. I have tried moving the sync plugs if different configurations and just end up with no image. Any help/advice/kicks in the ass for not understanding different syncs are appreciated.

Currently this is in a Ms. Pac cab (please don't flame me for that as the board/monitor where toast and I haven't cut a wire or drilled any holes).

Sync configurations don't seem to help. 50-60Hz pot doesn't seem to help. H-Hold gets it close but there is always something wrong there.
 

Attachments

  • IMG00726-20110608-2350.jpg
    IMG00726-20110608-2350.jpg
    98.6 KB · Views: 31
  • P1090176.JPG
    P1090176.JPG
    92 KB · Views: 22
No. I didn't bother capping it because the colors were all really good on it. I may have to do that though. I had a similar problem with a 25" on a Buck Hunter but it ended up being a wiring problem in that cabinet. This is the third cab I have tried this 19" on with the same results.
 
K7000's work just fine with this board. Sync should be connected to pin 10 only.

If it won't sync that way (with holds adjusted), recap it and reflow the input pins...
 
Back
Top Bottom