Icade 60-in-1 issue (shutting off)

gms1975

New member
Joined
May 14, 2010
Messages
21
Reaction score
0
Location
Saint Peters, Missouri
My 60 in 1 will play fine for about 20 to 30 minutes then shuts off. You can press buttons, but get no response. The LCD monitor goes to standby mode as it isn't getting a signal from the pcb anymore. Leds 1, 2, and 3 are off (2 normally flashes green while game is working right). Led 5 is green. I have several of these cabinets and I have never had this issue before. Can anybody help?
Thanks
 
Last edited:
What is the +5vdc measuring at the board connector? It should be between +5.00 and +5.20....
 
check to make sure that socketed chip is seated fully.

Otherwise, watch for when it shuts down and check to see if anything on the board feels hot...
 
Socketed chip is seated. None of the components feel hot. This time it went off, LED 2 stayed solid green along with LED 5.
 
Got a small fan? Set it so it blows on the board and see if that affects the shutdown...
 
The 60 in one does not heat up or use a lot power,they either work or just not working.
If it is still under warranty,send back to your vendor for warranty replacement maybe the easiest way to go.
 
Back
Top Bottom