Museum of the Game® & International Arcade Museum® Forums

This is the best way I've found to install any boards, fixtures, or anything else with screw holes without using a tape measure, pens, sharpies, whatever...


Put a piece of painters tape over the mounting hole locations on your board / marquee light (power strip in my example)

Poke holes exactly where you need the mounting screws.

Remove the tape and place it where you want to install the board/device.

Put screws or mounting hardware right where the holes in the tape are.

Can't get any easier than that....


20251014_153133(1).jpg 20251014_153208.jpg
20251014_154952.png
20251014_154924.jpg

20251014_155139.jpg
Back
Top Bottom