High speed gi lighting

Check the fuses on the power supply. Then, inspect the GI connector (should be two yellow wires) at the lower right corner of the supply. If the wires and/or connector are "browned", it will need to be rebuilt.

Chris
 
what about just half the lights on a High Speed (right side only) might have had a short with one of pop bumpers lights, now only GI left side works?
 
Fiddled with wires on plug and right side gi's work. Is the left in same plug?
 
Check and the sockets are the make the connection.I have problems with the G.I. too-the fuses were OK,but the sockets were bad.I replaced them and use the same fusesThe result- everything lights up
 
Alright. Let me explain this and then get help. I bought a cyclone with a new rotten dog board in it that the game didn't work. After talking to Jim at rotten dog he said that a very few had to be changed on the new board. Cut the wire at rs2 and add a jumper above at rs1. I said I had a high speed and we decided to switch boards, never really noticed the GI's were out and that the board could be problem. When I tried switching boards back a wire on the connector must have came loose. So when I fixed wire only half the GI's came on, I decided to switch board back again for shits and giggles and now they are back on. But now cyclone again will only power GI's. Well , I guess I will try to run jumper and see what happens. I guess I should have just run the jumper at first. I will advise. Thanks for the help.
 
Back
Top Bottom