HERCULES video just posted! TNT Amusements

Nice video Todd, thanks for sharing, never knew that you had to service this machine from underneath.
 
"Damn, that's a huge bitch"

That is really cool, didn't realize how large this pinball was until you put it next to Gorgar.

Very good video!!


;
 
i played one quite a bit when they had one at a local arcade that went out of business after a couple months. the owner was quite proud of it. uses a cue ball from a billiard set instead of a pinball, and the action was really slow on the one i played. more of a novelty than a kickass pin in my opinion.
 
ok, just watched the video, they have that thing in way better condition than the one i played, which the flippers were so beat on it would barely get the ball up the playfield.
 
Todd, thank you for the video. I've only ever seen one other video of this game, and the ball was realllllly realllllly dead, they couldn't play it very well.

Yours though appears to have really strong flippers, and pop bumpers, and slings so it plays about like a pin is supposed to.

One thing, that backglass is plexi isn't it? It was bending when you dropped it down, I hope it's not glass!
 
Thanks for sharing that video Todd. I remember playing this game as a kid. The only thing I hated about the machines I played was the flippers were weak.
 
Here's a picture of my 7 year old daughter playing one at the Rochester Gameroom Show this past Saturday...

Definitely puts it into perspective just how unbelievably large this sucker is! ;)
 
Hehe, that's hilarious!

I have a few NOS spinners for this game and maybe some other PF parts.
 
A local guy in the WV pinball club actually has the exact one from a gameroom I went to as a kid! I haven't played it since it was in the gameroom though, I don't think the loca guy has it set up or anything.

Wade
 
The backglass is plexiglass! The special coil board uses different transistors to drive the 120 volt coils on the playfield. The game had a boatload of cold solder connectors too...so we did our usual thing with all the boards. The machine may be available. We had a buyer in Pittsburgh for it, but I have not heard back from him since I sent the video. It is $1500 as it is...it will certainly need some cosmetic work...but playwise its great! I can also bring to allentown if the machine is prepaid for! Todd
 
There is one in a Warehouse a few miles from my house. Very cool machine just dont have the room for it!!

That was a cool video. Makes me want to play one now. Thanks or Sharing it!!!:cool:
 
Back
Top Bottom