Help with NEOTEC 2515C Caps

mike99

New member
Joined
Nov 16, 2011
Messages
7
Reaction score
0
Location
Washington
Hello,
I am new to this hobby but I have had pins for years. I just picked up MK4 that was converted in another game and I converting it to a XXXX in 1 from Paradise Arcade.

I have some questions concerning my NEOTEC 2515C cap kit, I tried searching with no luck. The boards appear to be factory fresh and not hacked.

According to the manual, c504 needs a 100uf 25v but I pulled off a 1000uf 25v? Which one, does it matter?

Here is the one that confuses me: The cap kit and manual calls for c920 to have a 10u 250v but mine is blank and I have a c924 that has a 22uf 250v cap installed. According to the manual and diagram, this cap (c924) should not be there? It is located on the bottom left of the board. Any sight? The CRT has NT-001 stamped on it.

Any help would be appreciated.

Thanks,
Mike
 
Hello,
I am new to this hobby but I have had pins for years. I just picked up MK4 that was converted in another game and I converting it to a XXXX in 1 from Paradise Arcade.

I have some questions concerning my NEOTEC 2515C cap kit, I tried searching with no luck. The boards appear to be factory fresh and not hacked.

According to the manual, c504 needs a 100uf 25v but I pulled off a 1000uf 25v? Which one, does it matter?

Here is the one that confuses me: The cap kit and manual calls for c920 to have a 10u 250v but mine is blank and I have a c924 that has a 22uf 250v cap installed. According to the manual and diagram, this cap (c924) should not be there? It is located on the bottom left of the board. Any sight? The CRT has NT-001 stamped on it.

Any help would be appreciated.

Thanks,
Mike

Mike,

I don't know about the 92* caps, but I had the same question about c504. I too pulled out a 1000uf 25v. I assumed it was just a typo in the manual and replaced it with a 1000uf 25v. I'm still having issues of my own but nothing blew up at least.
 
I just replaced everything with an identical cap that was pulled out. Everything appears to be working properly. The colors are nice and bright. One issue that I am having though, the lower left corner of the monitor is slightly blurry?
 
Back
Top Bottom